| FAQ desk |
|
|
|
|
1. Will installing The Fin void the warrantee ? Yes, Most any modification will void the warrantee
2. Does it take mechanical skills to install The Fin Fuel Vaporizer kit ? Yes : You must be skilled enough to remove and reinstall the intake manifold You must also be able to use measuring devices , cutting and drilling tools
3 . How long will the installation take ? Once the intake manifold is removed and cleaned the measuring drilling slicing and trimming only takes a few minutes . On metal manifolds you must allow 24 hours for the epoxy to cure.
4. Do you have to re calibrate the fuel injection after installation ? No : The computer controls will self adjust and allow for the cleaner emissions.
5. Will I get better fuel mileage with The Fin Fuel Vaporizer ? I do not advertize better fuel mileage because most modern engines are computer controlled which means the ignition is constantly advanced until it senses a knock . This system defeats better vaporization . Feedback from new customers however has shown an increase of 2 to 5 MPG on computer controlled cars. With an engine with adjustable ignition timing I have seen an increase of as much as 15%.
6. Will The Fin work on diesel engines ? Because a diesel engine uses direct injection, The Fin does not have the same effect as with port injection or carburetion . It may improve air flow in some diesel intake manifolds. I have not done any testing. Soon...
7. Will The Fin work on all different engines ? The Fin Fuel Vaporizer will work on any 4 stroke gas engine with an intake manifold that will accommodate the mounting of the Fin..
8. Will the Fin work with alternative fuels ? YES !!! Very well with ethanol, methanol, propane CNG and LNG all the alternative fuels can use the Fin to provide better mixing with the air for better combustion.
9. What does The Fin do ? The Fin creates a turbulence with out restriction . It accomplishes 3 different things in the intake manifold. Lower pressure, turbulence and added air flow by enhancing the boundary layer . |


